IBM System Storage TS7650G 3958 DD4, Installation Roadmap Manual

Page: 90 / 232

Table 17. Clustered TS7650G power cabling
Callout From On Device To On Device/Location
1
Power outlet Ethernet switch 1 (bottom) (E
SW-1) BJ10 Bottom PDU
2
Power outlet Ethernet switch 2 (top) (E
SW-2 TJ10 Top PDU
3
Power outlet TSSC Ethernet switch (if you
installed one) (SC SW) BJ4 Bottom PDU
4
Power outlet TSSC KVM switch (if you
installed one) (SC TSSC) TJ4 Top PDU
5
Power outlet 1 TSSC (if you installed one)
(SC) BJ5 Bottom PDU
6
Power outlet 2 TSSC (if you installed one
with a second power outlet)
(SC) TJ5 Top PDU
7
Power outlet KVM Switch BJ3 Bottom PDU
14
Top power outlet WTI network power switch TJ8 Top PDU
15
Bottom power
outlet WTI network power switch BJ8 Bottom PDU
16
Power outlet 1 Server A Power outlet 1 WTI network power
switch
17
Power outlet 2 Server A Power outlet 5 WTI network power
switch
18
Power outlet 1 Server B Power outlet 2 WTI network power
switch
19
Power outlet 2 Server B Power outlet 6 WTI network power
switch
Procedure
1. Label and connect the power cords according to Figure 20 on page 51 and
Table 17.
2. Go to “Clustered 1 Gb Ethernet switch Ethernet connections.”
Clustered Ethernet connections
The tasks in this section describe the network Ethernet connections to the 1Gb
Ethernet switches, the TSSC, and the customer network for both VTL and
OpenStorage with theTS7650G server in a clustered configuration.
Clustered 1 Gb Ethernet switch Ethernet connections
This task describes the 1Gb Ethernet switch connections for theTS7650G server in a
clustered configuration.
Before you begin
Notes:
v
Depending upon the model of the TSSC and TSSC network switch being used,
the port layout may differ from what is shown in Figure 21 on page 53 or
Figure 22 on page 55. If so, make the cable connections according to the port
number assignments specified in Table 18 on page 54 or Table 19 on page 55,
52
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
|
|
|
|
|
|
|
|
|