IBM System Storage TS7650G 3958 DD4, Installation Roadmap Manual

Page: 84 / 232

Table 15. Host fibre channel connections for stand-alone VTL configuration
Label From To Remarks
1
DD4A S1 1 HOST 1
2
DD4A S1 2 HOST 2
3
DD4A S2 1 HOST 3
4
DD4A S2 2 HOST 4
Procedure
1. Connect fibre channel cables according to Table 14 on page 45 and Table 15.
Note: The customer must use an additional connectivity device between the
optical fibre directly connected to RMSS optical adapters (for example, Fibre,
ESCON, or FICON) and an external public network. It can be a patch panel,
router, switch, or other suitable device. Optical fibre connectivity that does not
go over a public network does not require an additional connectivity device.
2.
Use Figure 17 on page 44 to verify that the recommended disk components are
cabled correctly. (Connections to the customer's host network not shown in this
figure).
3. Make any necessary adjustments to cable labeling or placement, then go to
“Powering-up the components” on page 69.
Figure 18. Host fibre channel connections for stand-alone VTL
46
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide