IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 157 / 257

Chapter 8. Removal and Replacement Procedures
8-9
12. Remove the flat-head screws on each side to remove the left and right
rails from the chassis (Figure 8-16).
Figure 8-16. Removing side rails from the library chassis
Installing the Library in a Rack
For details on the rack mount kit components, see “Installing in a Rack” on page 3-5.
1. Determine the location in your rack for your library and mark with a pencil. For
details on rack mount locations, see “Installing in a Rack” on page 3-5.
2. Attach the left and right front brackets to the front of the library chassis
using two flat-head screws on each side (Figure 8-17). Use the
bottom two
screw holes on each side.
Figure 8-17. Attaching the front brackets to the library chassis
3. Attach the left and right rear brackets to the left and right front rails
using two round-head screws on each side (Figure 8-18).
Note: Run the hook and loop fastener strap through the slot on the right rear
bracket and attach it back upon itself.
6 5 3
a29z0009
6
5
3
6
3 4
8
a29z0017
8
3
8
4
1 2 5 6
10