IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 158 / 257

8-10
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Figure 8-18. Attaching the rear brackets to the rails
Important: Do NOT tighten these screws completely at this time.
4. Slide in the rear rails from back to front, to create the rail assemblies. Ensure
the screw holes face outwards (Figure 8-19).
Figure 8-19. Creating the rail assemblies
5. Install the rail assemblies into the rack (Figure 8-20). Ensure the three holes in the
front of the unit align with the 1U space marked on the vertical rails in Step 1.
Secure the rails to the rack using four flat-head screws on each side of the rack.
Use both of the two screw locations on the rear of the rack rail. Use the
top and
middle screw locations on the front of the rack rail.
a29z0019
5
6
10
1
2
12
7
a29z0018
7
9