4. Load the SLR5-4GBSL test cartridge into the 7207-122 Tape Drive (see
“Loading Tape Cartridges” on page 14).
Note: Use only the IBM test cartridge, part number 59H3661. Use of any other
test cartridge could cause erroneous test results or lengthen the time
needed to complete the test.
5. Press the 7207-122 Tape Drive power switch to turn on the power.
After approximately 5 minutes, the status light does one of the following:
Flashes red to indicate an error
Flashes green to indicate the completion of a successful self test
Did the 7207-122 Tape Drive self test terminate with a flashing green status
light?
NO
Replace the 7207 Tape Drive.
Note: If the 7207-122 Tape Drive is the FRU that was isolated by
the diagnostics and has recently been replaced because of
a similar problem, contact your service personnel.
YES
The problem is either fixed or has not been isolated by the self test.
A more in-depth analysis may be required. Contact your next level
of service support.
Chapter 5. Performing Service
35
Summary of Contents for System Storage 7207
