![background image](http://html1.mh-extra.com/html/ibm/system-storage-7207/system-storage-7207_setup-operator-and-service-manual_4066817045.webp)
Step 8
This step verifies that the 7207-122 Tape Drive has been properly configured to the
RS/6000.
1. Clean the tape drive. See “Cleaning the Tape Drive” on page 16.
2. At the system prompt, type
cfgmgr
to configure the 7207-122 Tape Drive and
make its status
Available
.
To ensure that the 7207-122 Tape Drive has been correctly configured to the
RS/6000, see Chapter 2, “Setting Up the 7207 Tape Drive,” on page 3.
Is the 7207-122 Tape Drive properly configured to the RS/6000?
NO
Go to Step 9.
YES
Go to Step 9.
Step 9
This step runs the AIX diagnostics to determine the problem.
Run the diagnostics on the 7207-122 Tape Drive. Have the test cartridge (part
number 59H3661) available for when the diagnostics prompt you to load the
cartridge. For instructions on running diagnostics, refer to your AIX manuals.
Do all of the diagnostic routines pass?
NO
Go to Step 10.
YES
Go to Step 11.
Step 10
This step determines whether it is necessary to run the 7207-122 Tape Drive self
test.
Did the AIX diagnostics isolate the 7207-122 Tape Drive as the failing FRU?
NO
Replace the FRU that was isolated by the diagnostics and identified
by the service request number.
YES
Go to Step 11.
Step 11
This step runs the 7207-122 Tape Drive self test to determine the problem.
1. If the 7207-122 Tape Drive is installed, remove it by performing steps 1-12 in
Chapter 6, “Moving the 7207 Tape Drive” on page 37.
Note: Make sure that the SCSI cable and terminator are not attached to the
7207-122 Tape Drive (or the self test may not function properly).
2. Attach the power cable to the 7207-122 Tape Drive, then plug it into an
electrical outlet. Make sure that the power to the tape drive is off.
3. Set the address switch to 9 (see “Step 5. Setting the SCSI Address” on
page 6).
34
7207 Tape Drive Setup, Operator, and Service Guide
Summary of Contents for System Storage 7207
