Step 8. Connecting the SCSI Bus Cable
To connect the SCSI bus cable:
1. If installed, remove the connector covers.
2. On the rear of the 7207-122 Tape Drive (
.1/
in Figure 4), attach the device
connector end of the SCSI bus cable
.2/
to one of the SCSI connectors
.3/
.
3. Make sure that the connector is fully engaged.
4. Secure the cable to the 7207-122 Tape Drive with the thumbscrews
.4/
provided on the cable.
Figure 4. Connecting the SCSI Bus Cable to the 7207-122 Tape Drive. The view is from
the side.
5. Connect the other end of the SCSI bus cable as follows:
If the 7207-122 Tape Drive is the only device attached to the system,
connect the cable to the RS/6000 (see Figure 5 on page 9).
If the 7207-122 Tape Drive is part of a multiple-device configuration,
connect the cable to the next device (see Figure 6 on page 9).
If the 7207-122 Tape Drive is installed in the middle of a narrow bus,
two 68-pin-to-50-pin device-to-device cables will be required, one for
each device on either side of the 7207-122 Tape Drive.
8
7207 Tape Drive Setup, Operator, and Service Guide
Summary of Contents for System Storage 7207
