IBM SY27-0345-06, Service And Maintenance Manual

Page: 86 / 148

3
Fasten the front of the assembly to the front frame using the supplied screws.
4
Insert an optional adapter into the module slot to ensure the adapter fits into
the assembly correctly.
5
Tighten all screws on the assembly.
6
Attach the dc power cable to the connector on the left-hand side of the riser
card assembly. Make sure the connector with the jumper is connected to the
riser card.
7
Connect the jumpers between the base power supply and the adapter power
supply together.
8
Replace the IBM 2210 cover as described in “Reinstalling the Cover” on
page 4-4.
9
Verify that the IBM 2210 is functioning correctly by using “MAP 0210: Verify
Operation” on page 2-23.
Removing the Adapter Enablement Feature
1
Remove the IBM 2210 cover as described in “Removing the Cover” on
page 4-2.
2
Detach the dc power cable from the connector on the left-hand side of the
riser card assembly.
3
Remove the front screws of the assembly from the front frame.
4
Remove the screw that fastens the rear of the assembly to the system board.
5
Carefully lift the assembly and riser board out of the socket on the system
board.
6
Remove the adapter power supply from the power supply cover.
Installing Optional Adapters
Refer to “Handling Static-Sensitive Devices” on page 4-2 before removing or
installing any of the optional adapters.
4-36
2210 Service and Maintenance