IBM Storwize V5000 Gen 2 Series, Quick Installation Manual

Page: 127 / 178

6. Replace the new enclosure in rack, as described in “Installing or replacing an expansion enclosure in
a rack: 2077-92F ” on page 47.
7. Reinstall the remaining parts into the enclosure, as described in the following topics. You can install
the parts in any order.
Important: Ensure that a mechanical lift is available and in place to support the additional weight as
the FRUs are reinstalled in the enclosure.
• “Installing or replacing a power supply: 2077-92F ” on page 67
• “Installing or replacing a drive: 2077-92F ” on page 59
• “Installing or replacing a secondary expander module: 2077-92F ” on page 63
• “Installing or replacing an expansion canister: 2077-92F ” on page 48
• “Installing or replacing a fan module: 2077-92F ” on page 75
• “Installing or replacing the top cover: 2077-92F ” on page 58
8. Reconnect the SAS cables, as described in “Removing and installing a SAS cable: 2077-92F ” on
page 72.
9. Reconnect the power cables, as described in “Powering on the 5U expansion enclosure: 2077-92F ”
on page 108.
10. Run the next recommended fix procedure in the management GUI to set the serial number of the
2077-92F enclosure.
Removing the display panel assembly: 2077-92F
You can remove the display panel assembly from a 2077-92F expansion enclosure.
Procedure
1. Slide the expansion enclosure out of the rack, as described in “Removing an expansion enclosure from
a rack: 2077-92F ” on page 79.
2. Remove the top cover, as described in “Removing the top cover: 2077-92F ” on page 42.
3. Press the release tab at the top of the display panel assembly, as shown in Figure 106 on page 101.
Figure 106. Removing the display panel assembly
4. Carefully pull the display panel assembly, which is shown in Figure 107 on page 102, out of the
chassis.
Chapter 2. Installing the system hardware 101