IBM SAN64B-6, Installation, Service And User Manual

Page: 37 / 122

than 40.64 cm (16 in.), so it will install into a rack with a maximum depth of 81.28 cm (32 in.) – 5.08 cm
(2 in.), which equals 76.2 cm (30 in.).
Observe the following when mounting the device:
• Two people are required to install the device in a rack. One person holds the device, while the other
screws in the front and rear brackets.
• Before mounting your device, review any specific installation and facility requirements in the hardware
installation guide for the device.
• Hardware devices illustrated in these procedures are for reference only and may not depict the device
that you are installing into the rack.
Time and items required
Allow 15 to 30 minutes to complete the installation.
The following items are required to install the device using the Universal Four-Post Rack Kit:
• #2 Phillips torque screwdriver
• 1/4-inch slotted-blade torque screwdriver
Figure 4. Items in the Universal Four-Post Rack Kit
Chapter 3. Mounting the switch 13