IBM SAN50C-R, Installation, Service And User Manual

Page: 63 / 86

To connect the MGMT 10/100/1000 Ethernet port to an external hub, switch, or
router, follow these steps:
1.
Connect the appropriate modular cable to the MGMT 10/100/1000 Ethernet
port.
Use a modular, RJ-45, straight-through UTP cable to connect the MGMT
10/100/1000 Ethernet port to an Ethernet switch port or hub.
Use a cross-over cable to connect to a router interface.
2. Connect the other end of the cable to the device.
Connecting to a Fibre Channel Port
The Fibre Channel ports are compatible with LC-type fiber-optic. You can use these
ports to connect to the SAN or for in-band management. For information about
configuring the switch for in-band management, see the Cisco NX-OS Fundamentals
Configuration Guide. The IBM SAN50C-R supports both Fibre Channel and Gigabit
Ethernet protocols for SFP+ transceivers. Each transceiver must match the
transceiver on the other end of the cable, and the cable must not exceed the
stipulated cable length for reliable communication. For information on how to get
the list of supported SFP+ transceivers for your software release, see the NX-OS
release notes.
Note: Class 1 laser product.
Note: Invisible laser radiation may be emitted from disconnected fibers or
connectors. Do not stare into beams or view directly with optical instruments.
CAUTION:
Wear an ESD wrist strap connected to the chassis when handling transceivers.
Keep optical connectors covered when not in use, and do not touch connector
ends. The fiber-optic connectors must be free of dust, oil, and other
contaminants.
Removing and Installing SFP Transceivers
Note:
Removing and installing an SFP transceiver can shorten its useful life. Do not
remove and insert SFP transceivers more often than is absolutely necessary. We
recommend that you disconnect the cables before installing or removing SFP
transceivers to prevent damage to the cable or transceiver.
Note: Use only IBM recommend SFP transceivers on the IBM SAN50C-R switch.
Each SFP transceiver is encoded with model information that enables the switch to
verify that the SFP transceiver meets the requirements for the switch. For
instructions specific to the transceiver type, see the “SFP Transceiver Specifications”
section on page B-4.
The IBM SAN50C-R switch supports SFP transceivers with the following types of
latching devices:
v Mylar tab latch
v
Bale-clasp latch
Chapter 4. Initial Setup and Verification
39