IBM SAN50C-R, Installation, Service And User Manual

Page: 56 / 86

1
Rack-mounting rail (4x)
2 Shelf bracket (2x)
3 Slider rail (2)
4 Crossbar (2)
5 10-32 screws (2x)
To install the shelf bracket in an EIA rack, follow these steps.
1. Position a shelf bracket inside the rack-mounting rails. Align the screw holes at
the front of the shelf bracket with the holes in the front rack-mounting rail.
Attach the shelf bracket to the front rack-mounting rail using a minimum of
four 12-24 or 10-24 screws.
Note: The bottom hole of the shelf bracket should align with the bottom hole
of a rack unit on the rack-mounting rail (the hole immediately above the
1/2-in. spacing).
2. Repeat with the other shelf bracket.
3. Verify that the shelf brackets are at the same height (using the level or tape
measure as desired).
4. Attach the crossbar to the shelf brackets using the 10-32 screws.
5.
Insert the slider rails into the shelf brackets and attach them to the rear
rack-mounting rails using a minimum of four 12-24 or 10-24 screws.
Installing the Shelf Bracket Kit into an EIA Rack
rav00045
5
4
3
2
1
32
SAN50C-R Installation, Service, and User Guide