IBM SAN06B-R, Installation, Service And User Manual

Page: 49 / 85

20 20 dc1400 -- -- Offline VE
21 21 dc1500 -- -- Offline VE
22 22 dc1600 -- -- Offline VE
23 23 dc1700 -- -- Offline VE
ge0 id 1G No_Light FCIP
ge1 id 1G No_Light FCIP
ge2 id 1G No_Light FCIP
ge3 id 1G No_Light FCIP
ge4 id 1G No_Light FCIP
ge5 id 1G No_Light FCIP
sw7800:admin>
4. Verify the correct operation of the switch in the fabric by entering the
fabricShow
command from the workstation. This command provides general
information about the fabric.
Backing up the configuration
You should save all key configuration data for the switch (including license key
information) and upload it to a FTP server for emergency reference. Back up the
configuration on a routine basis to ensure that a complete and current
configuration is available if needed.
After configurations are complete, back up the configuration by entering the
configUpload command and following the prompts.
sw7800:admin> configupload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address
host : 192.168.0.100
User Name user : anonymous
Path/Filename [ home dir /config.txt]:
Section (all|chassis|switch [all]): all
configUpload complete: All selected config parameters are uploaded
sw7800:admin>
The configUpload command uploads the switch configuration to the server so that
it is available for downloading to a replacement switch, if necessary. For specific
instructions about how to back up and restore the configuration, see the
“Maintaining Configurations” chapter in the
Fabric OS Administrator's Guide . The
switchShow , fabricShow , and configUpload commands are described in detail in
the Fabric OS Command Reference .
Managing license keys (optional)
Depending on what has been ordered, certain licenses are factory-installed on the
switch. Feature licenses might be included as a paperpack item in the switch
shipping carton. This paperpack provides you with keys to unlock the features.
You can also purchase licenses separately from IBM.
Attention: Retain this paperpack in a safe place. The transaction keys in the
paperpack are required for activation of optional features on the switch. After a
feature is activated, its activation key is associated with a specific product WWN
and serial number.
Refer to the following sections for information about viewing the current licenses,
adding a license, or removing a license. For more information on the following
procedures, see the
Fabric OS Administrator's Guide and the Fabric OS Command
Reference .
Chapter 2. Installing and configuring the SAN06B-R
23