IBM S822LC, Manual

Page: 109 / 244

What to do next
Prepare the system for operation. For instructions, see “Preparing the 8335-GTB system for operation after
you remove and replace internal parts” on page 198.
Removing and replacing the BMC card in the 8335-GTB
Learn how to remove and replace the BMC card in the IBM Power System S822LC (8335-GTB) system.
Removing the BMC card from the 8335-GTB
Learn how to remove the BMC card in the IBM Power System S822LC (8335-GTB) system.
Before you begin
Power off the system and place it in the service position. For instructions, see “Preparing the 8335-GTB
system to remove and replace internal parts” on page 195.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
2. If needed, label and remove the cables from the BMC card.
3. Using the blue tab, open the release latch (A) at the socket end of the BMC card as shown in
Figure 113 on page 94. Pull up on the blue tab (B) at the rear of the card.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
93