IBM PS700, Installation And User Manual

Page: 33 / 74

Attention:
v
To maintain proper system cooling, do not operate the BladeCenter unit without a blade server,
expansion unit, or blade filler installed in each blade bay.
v
When you remove the blade server, note the bay number. Reinstalling a blade server into a different
bay from the one where it was removed might have unintended consequences. Some configuration
information and update options are established according to bay numbers. If you reinstall the blade
server into a different bay, you might have to reconfigure the blade server.
Perform the following procedure to remove the blade server.
1.
Read the Safety topic and the “Installation guidelines” on page 19.
2. If the blade server is operating, shut down the operating system.
3.
Press the power-control button (behind the control-panel door) to turn off the blade server. See
“Turning off the blade server” on page 13.
4. Wait at least 30 seconds for the hard disk drive to stop spinning.
5. Open the two release handles, as shown by
1
in Figure 5. The blade server moves out of the bay
approximately 0.6 cm (0.25 inch).
6. Pull the blade server out of the bay. Spring-loaded doors farther back in the bay move into place to
cover the bay temporarily.
7. Carefully lay the blade server on a flat, static-protective surface, with the cover side up.
8.
Place either a blade filler or another blade server in the bay within 1 minute. The recessed
spring-loaded doors move out of the way as you insert the blade server or filler blade.
Figure 5. Removing the blade server from the BladeCenter unit
Chapter 3. Installing and removing options
21