7.12 1060 Battery
Cover (1005)
Air baffle (1015)
Adapters (1035) (from system-board slots J1, J3, J4, and J6).
Disconnect any cables necessary for removal.
CAUTION:
The lithium battery presents a fire, explosion, or severe burn risk. Do
not recharge it, disassemble it, heat it above 100°C (212°F), incinerate
it, or expose its cell contents to water. Dispose of the battery as
required by local ordinances or regulations. When replacing the battery,
use only Part No. 33F8354. Use of another battery could result in
ignition or explosion of the battery. Replacement batteries can be
ordered from IBM or IBM Authorized Dealers.
Warning: The battery is located on the system board. Be careful when
removing or replacing the battery. If the battery clip is broken the
system board must be replaced.
Note: After you replace the battery, run the set configuration program
from the hard disk drive.
PICTURE 19
IBM PS/2 Model 90 XP 486 HMR
1060 Battery
¦ Copyright IBM Corp. 1990, 1991
7.12 - 1