Proceed to the procedure for completing the drive replacement. For instructions, see “Completing the
procedure by using the HSM” on page 80.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1.
With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note:
Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2.
Slide the solid-state drive halfway into the EDR1 PCIe storage enclosure.
3.
Select the drive that you want to replace and press Enter on the console.
Important:
When you press Enter, after your selected time delay, the service indicator light comes on
(solid) for 18 seconds. You then have 18 seconds to slide the drive all the way in and then lock it in
place by pushing in the drive handle. You can set an appropriate time delay of 01 - 19 minutes to
allow adequate time to access the disk drive or solid-state drive.
4.
When the solid-state drive identify LED turns on solid, slide the solid-state drive all the way into the
EDR1 PCIe storage enclosure until it is fully seated. Then rotate the handle
(A)
to the locked position.
See Figure 52.
5.
On the console, press Enter to indicate that you have installed the solid-state drive.
6.
Install the bezel
(B)
.
Proceed to the procedure for completing the drive replacement. For instructions, see “Completing the
procedure by using the HSM” on page 80.
Figure 52. Replacing a solid-state drive in the EDR1 PCIe storage enclosure.
Disk drives or solid-state drives
79
Summary of Contents for Power 720 Express 8202-E4B
