IBM Power 720 Express 8202-E4B, Installation Manual

Page: 39 / 64

For IBM i V5R4 and earlier only: The service tool console IP address can be
specified as the name.
2)
If you are using IBM i V5R4, set the target partition to 1 . If you are using IBM i V6R1 and
later, press the Tab key. The Service TCP/IP Address field is enabled.
3) IBM i V6R1 and later: Specify the service TCP/IP address. Enter the LAN console adapter IP
address.
4) Click Next .
e. Specify the LAN console interface information.
1) In the Service TCP/IP Address field, type the IP address that you recorded.
2)
In the
Service Subnet Mask
field, type the subnet mask that you recorded.
3) In the Service gateway address field, type the default gateway that you recorded.
4)
The system serial number must match the tag on the server. It should be 7 characters long,
without a dash.
5) Set the Target partition to 1.
6) Click Next .
f. Specify the device ID. If you are prompted to specify a service tools device ID, enter
QCONSOLE
.
Click Next .
g. If you are using a version that is earlier than V6R1, create an access password.
Note: Be sure to record this case-sensitive password because it must be entered each time the
console connection is opened.
h.
Click
Next > Finish
. Your session is now ready to connect. Double-click the session name to start
the connection.
6. Power on the server by completing the following steps:
a.
Set the manual IPL by completing the following steps:
1) Locate the server's control panel. Look for the blue tab on the front of the server. Push it to the
side, and pull the control panel out slowly.
2) Press the Up arrow key until you see 02, and press Enter.
3) Press Enter again, and you will see a Less Than symbol ( < ) move to the N .
4) Press the Up Arrow key. The N changes to an M .
5) Press Enter.
6) Press Enter twice. 02 is displayed on the control panel.
b.
Afteryou have the server set to a manual IPL, push the white power button to power on the
server.
7. Connect the console by completing the following steps:
a.
Monitor the console status. After the status changes to
Pending Authorization
, the Service Tools
Sign-On window opens.
Note: The Service Tools Sign-On window might open behind the Operations Console window.
Resize or move the Operations Console window to locate the Service Tools Sign-On window.
b. Sign on to the Service Tools application. To sign on to the Service Tools application, enter 11111111
for the user ID and password.
c. IPL and configure the system.
d.
If your session does not connect, wait for the power-on process to stop on an attention or IPL
failure system reference code (SRC), such as A6005008 or B2xxxx. If the power on stops at
A6005008, leave the server in this state and call your IBM service provider for assistance.
8.
Cabling the server and setting up the console
27