IBM PCI Dual Channel Ultra3 SCSI Adapter, Installation And Using Manual

Page: 21 / 42

b. Move the cursor down until SPOT resource is highlighted. The SPOT
resource should look similar to the following:
spot_AIX433 resources spot
The format of the SPOT name is: spot_<lppsource_name>.
<lppsource_name> was the name that you recorded in a previous step.
c. When SPOT resource is highlighted, press Enter to select this option. The
Network Install Operation to Perform screen displays with the reset option
highlighted for selection.
d. Move the cursor until cust is highlighted, and press Enter to select this
option. The Customize a SPOT screen displays with the Source of Install
Images highlighted for selection.
e. Press F4 to display the list of installation images and select the appropriate
lppsource.
f. Move the cursor until the appropriate lppsource is displayed. For example:
lppsource_AIX433 resources lpp_source
Press Enter.
g. Move the cursor to fileset names and type
devices.pci.00102100
.
h. To start the SPOT update, press Enter. This operation can take up to 15
minutes.
i. Repeat steps 4.g and 4.h for all device drivers you have selected:
devices.pci.00102100
devices.pci.00100f00
devices.commom.IBM.scsi
Proceed to “Installing Device Drivers on the SP Nodes”
Installing Device Drivers on the SP Nodes
To install device drivers on the SP nodes, perform the following:
__ 1. To make sure that the lppsource directory is exported to the nodes, type
showmount -e
at the system prompt. If the directory is exported to the nodes,
the result should look similar to the following:
/spdata/sys1/install/AIX433/lppsource (everyone)
__ 2. If the directory is not exported, you may temporarily export the directory by
typing the following:
exportfs -i /spdata/sys1/install/<lppsource_name>/lppsource
__ 3. To perform an NFS mount of the lppsource directory, type the following:
dsh mount <controlwks>:/spdata/sys1/install/<lppsource_name
>/lppsource /mnt
<controlwks>
is the name of the Control Workstation recognized by the nodes.
<lppsource_name>
is the name you recorded earlier in “Checking System
Prerequisites” on page 7.
Chapter 4. Installing the Device Driver on the RS/6000 SP System
11