IBM PCI Dual Channel Ultra3 SCSI Adapter, Installation And Using Manual

Page: 20 / 42

__ 10. To verify that the device driver is already installed on the node(s), type the
following at the system prompt:
dsh "lslpp -l devices.pci.00102100* 2>&1" |more
dsh "lslpp -l devices.pci.00100f00* 2>&1" |more
dsh "lslpp -l devices.common.IBM.scsi* 2>&1" |more
__ 11. If the device driver is already installed on the node, contact your service
provider to have the adapter installed.
OR
If the device driver is not installed on the node, proceed to “Installing Device
Drivers on the SP Nodes” on page 11.
Installing Software on the Control Workstation
Note: If your system is
partitioned; that is, there is more than one operating system
among the nodes, you can only install this adapter in nodes that have AIX 4.3.3
or later.
__ 1. If you are not logged into the Control Workstation as a root user, log in now. You
may also need to export the working collective. Refer to “Checking System
Prerequisites” on page 7.
__ 2. Insert the installation media into the drive of the Control Workstation.
__ 3. Transfer the files to the Control Workstation’s lppsource, as follows:
a. Type
smitty bffcreate
, and then press Enter.
b. Select the input device/directory and press F4. Move the cursor to the
appropriate input device, and then press Enter.
c. Move the cursor to SOFTWARE Package to Copy and press F4 to select
the software to be installed. Use the F7 key to select the following device
driver(s) at the system prompt:
devices.pci.00102100
devices.pci.00100f00
devices.common.IBM.scsi
Press Enter.
d. Move the cursor down to DIRECTORY for Storing Software Package and
type the appropriate lppsource destination directory as follows, using the
<lppsource_name> you recorded earlier:
/spdata/sys1/install/<lppsource_name>/lppsource
e. To begin copying the files, press Enter.
Note: This step may take several minutes while the directory table of
contents is updated.
__ 4. To update the SPOT (Shared Product Object Tree), perform the following:
a. Type
smitty nim_res_op
at the system prompt. The Resource Name screen
displays with the following highlighted:
boot resources boot
10
Installation and Using Guide