2 FPGA CODE (If necessary)
3 BOOT CODE
4 Activate the new version of A-CPSW FPGA. picocode by entering the command:
SAVE ALL
SWAP FPGA_PICOCODE 9 (or 11).The telnet session, if any, is broken.
Login as Administrator on the A-CPSW console.
5 Activate the new version of A-CPSW microcode by entering the command:
SWAP MICROCODE and confirm with Y. Your remote TELNET session is broken and you
have to connect locally an ASCII terminal to the A-CPSW console port to get the connectivity
again.
Login as Administrator on the A-CPSW ASCII console.
6 If you do not have redundant A-CPSW, go to step 7.
If you had already swapped new FPGA picocode and microcode on both A-CPSW
modules go to step 7. Check the new levels of codes .
The following table lists the microcode and FPGA versions that
must be displayed at completion of the upgrade. Use the following commands
SHOW DEVICE
SHOW MODULE <n> VERBOSE
v.3.1.9
v.3.1.9
B52
A-CPSW
Boot EEPROM
Version
Flash EEPROM
version
FPGA version
Component
Now make this A-CPSW be secondary again as it was before the beginning of the
migration :
SET DEVICE ROLE SECONDARY
SAVE ALL
RESET ATM_SUBSYSTEM
The hub will reset and the backup A-CPSW will become active.
Perform the step 6 again on the other A-CPSW.
Installation Instructions
Copyright IBM Corp. 1998
Page 12
June 17 1998
EC : F34705
PN : 26L0227
