Make sure you can reach the TFTP server by entering:
PING <ip address of the TFTP server>
(Stop PING by entering: Ctrl+C)
Start the download inband procedure by entering:
DOWNLOAD INBAND
When prompted, type "Y" to confirm.
Wait for successful termination of the download operation. The message Download
successful is displayed.
This may also be checked by displaying the TFTP last transfer result with the command:
"SHOW TFTP".
The command "SHOW DEVICE" displays the new BOOT code version which will become
active after an A-CPSW reset.
It should display: v.3.1.9.
If you have only one A-CPSW module go to step 6.
If you were upgrading your backup A-CPSW module go to step
6.
2.5 Step 5: Make the backup A-CPSW active
If you have a redundant A-CPSW make the backup one active by entering on the active
A-CPSW:
SET DEVICE ROLE SECONDARY
SAVE ALL
RESET ATM_SUBSYSTEM
Log in as the Administrator on the A-CPSW console
The hub will reset and the backup A-CPSW will become active. GO TO STEP 2.
2.6 Step 6: Activate the new A-CPSW microcodes and the
new FPGA picocode
DO NOT PERFORM ANY SWAP BEFORE HAVING DOWNLOADED :
1 OPERATIONAL CODE
Installation Instructions
Copyright IBM Corp. 1998
Page 11
June 17 1998
EC : F34705
PN : 26L0227
