SET TFTP FILE_NAME
Type the full path name of the FPGA file when prompted
SET TFTP TARGET_MODULE <n> (n=9 or 11 depending of active A-CPSW position).
SAVE TFTP
2 Make sure you can reach the TFTP server by entering:
PING <ip adress of the TFTP server>
(Stop PING by entering: Ctrl+C)
3 Start the download inband procedure by entering:
DOWNLOAD INBAND
When prompted, type "Y" to confirm.
4 Wait for successful termination of the download operation (it may take up to 10 minutes). The
message
Download successful is displayed.
This may also be checked by displaying the TFTP last transfer result with the command:
"SHOW TFTP".
The command SHOW MODULE <n> VERBOSE (n=9 or 11 depending on A-CPSW active
position) displays the FPGA level in backup.
It should appear as B52.
2.4 Step 4: Download Inband the 8260 A-CPSW boot
microcode
Upgrade the new active A-CPSW boot microcode as follows:
1 Log in as the Administrator on the A-CPSW console
2 Perform the command:
SET DEVICE MIGRATION NOT_ALLOWED
3 Upgrade the A-CPSW boot microcode (Boot EEPROM) as follows:
Configure the TFTP parameters by entering the following commands:
Ø
SET TFTP SERVER_IP_ADDRESS <ip address of the TFTP server>
Ø
SET TFTP FILE_TYPE BOOT
Ø
SET TFTP FILE_NAME
Ø
Type the full path name of the boot microcode file when prompted (its actual name is
indicated in the Readme file).
Installation Instructions
Copyright IBM Corp. 1998
Page 10
June 17 1998
EC : F34705
PN : 26L0227
