Administrator password
Setting an administrator password deters unauthorized persons from changing
configuration settings. If you are responsible for maintaining the settings of several
computers, you might want to set an administrator password.
After you set an administrator password, a password prompt is displayed each
time you try to access the Configuration/Setup Utility program. If you type the
wrong password, you will see an error message. If you type the wrong password
three times, you must turn the computer off and start again.
If both the user and administrator passwords are set, you can type either
password. However, to change any configuration settings, you must use your
administrator password.
Setting, changing, and deleting a password
To set, change, or delete a password, do the following:
Note:
A password can be any combination of up to seven characters (A- Z, a-z,
and 0-9).
1.
Start the Configuration/Setup Utility program (see “Starting the
Configuration/Setup Utility program” on page 25).
2.
From the Configuration/Setup Utility program menu, select
Security
. Read the
information displayed on the right side of the screen.
Using Security Profile by Device
Security Profile by Device is used to enable or disable user access to the following
devices:
IDE controller
When this feature is set to
Disable
, all devices connected to the
IDE controller (such as hard disk drives or the CD-ROM drive)
are disabled and will not be displayed in the system
configuration.
Diskette Drive Access
When this feature is set to
Disable
, the diskette drive cannot be
accessed.
Diskette Write Protect
When this feature is set to
Enable
, all diskettes are treated as if
they are write-protected.
To set Security Profile by Device, do the following:
1.
Start the Configuration/Setup Utility program (see “Starting the
Configuration/Setup Utility program” on page 25).
2.
From the Configuration/Setup Utility program menu, select
Security
.
3.
Select
Security Profile by Device
.
4.
Select the desired devices and settings and press Enter.
5.
Return to the Configuration/Setup Utility program menu and select
Exit
and
then
Save Settings
.
Other settings in the Configuration/Setup Utility program
The information in this section contains instructions for changing the startup
sequence.
26
User Guide
Summary of Contents for NetVista 6029
