IBM Netfinity 3500, User Handbook Manual

Page: 103 / 294

Installing or Removing Drives in Bays 5 and 6
This section gives the procedure for installing a drive in bays 5 and
6. If you want to remove a drive, skip steps 3 and 4.
Note: You can install only 3.5-inch hard disk drives in bays 5 and 6.
Before you begin:
Ÿ
Read “Electrical Safety” on page 54 and “Handling
Static-Sensitive Devices” on page 55.
Ÿ
Read “Termination Requirements” on page 75.
Note: You might need to disconnect cables from drives that are
already installed in the server.
To install a drive in bays 5 and 6:
1. Remove the server cover (see “Preparing to Add Options” on
page 56).
2. Remove the lower drive bracket, as described in step 5 on
page 80.
3. Touch the static-protective package containing the new drive to
any unpainted metal surface; then, remove the drive.
4. Using the instructions that come with the drive, together with
these instructions, verify that any switches or jumpers on the
drive are set correctly. Change the settings if necessary. For
information about termination requirements, see “Termination
Requirements” on page 75.
Chapter 4. Installing Options
85