Figure 6: Components to Remove from the Rear of the Device
Remove Components
Before lifting the device, you must remove the following components:
■
Power supplies
■
Switch Control Boards (SCBs)
■
I/O Cards (IOCs)
■
Services Processing Cards (SPCs)
■
Fan tray
To remove the components from the device:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see the
IBM Ethernet Appliance J58S Hardware Guide
.
2.
Slide each component out of the chassis evenly so that it does not become stuck
or damaged.
3.
Label each component as you remove it so you can reinstall it in the correct
location.
4.
Immediately store each removed component in an electrostatic bag.
5.
Do not stack removed components. Lay each one on a flat surface.
NOTE:
For complete instructions on removing device components, see “Install the
Ethernet Appliance Without a Mechanical Lift” in the
IBM Ethernet Appliance J58S
Hardware Guide
.
Step 3: Install the Device
■
11
Step 3: Install the Device
