IBM J15, Manual

Page: 106 / 142

Figure 73. Connectors for the upper cable management arm
1 Inner connector on the upper CMA
2 Connector base on inner rail member
3 Outer connector on the upper CMA
4 Connector base on outer rail member
5 Support rail connector on the upper CMA
6 Connector base on outer rail member
1. Press the latch on the connector base on the upper CMA assembly ( 5 in Figure 73 on page 78).
2. Pull the connector to remove it from the connector base on the right support rail ( 6 in Figure 73 on
page 78).
3. Press the latch on the outer connector of the upper CMA assembly ( 3 in Figure 73 on page 78).
4. Remove the outer connector from the inner member of the left support rail ( 4 in Figure 73 on page
78).
5. Remove the inner connector of the upper CMA assembly ( 1 ) from the inner member of the left
support rail ( 2 ), as shown in Figure 73 on page 78.
Remove the lower CMA assembly
Note: The procedure for removing the lower CMA assembly is the same as the procedure to remove the
upper CMA assembly. However, the connector locations are reversed. For example, the connector base of
the upper CMA ( 5 in Figure 73 on page 78) connects to the right rail. The connector base of the lower
CMA ( 11 in Figure 74 on page 79) attaches to the left rail.
78 IBM Cloud Object Storage System
™
Version 3.15.6: J15 Appliance Manual