IBM IBM 9077, Get Connected

Page: 303 / 342

GRF Configuration Files
285
# exit.
# If only 3 values are designated, the first value will be repeated as the
# fourth value.
#
# No whitespace is allowed in any field.
#
# ie.
# 5,6 997,998 1,0x4,8,15
# When port cards 5 & 6 receive an IP packet with a logical address of 997 or
# 998, it will then attempt to randomly forward the packet to one of the
# mapped ports 1, 4, 8 or 15.
#
################################################################################
#* * 5 # default mapping for all LAs for all portcards.
#5 * 6 # default mapping for LAs for portcard 5.
################################################################################
# IP mapping.
################################################################################
# * 0xfc0 3,8 # default mapping of IP for all portcards.
* 0xfc0 0x40 # default mapping of IP for all portcards.
################################################################################
#5 1-100 9 # default mapping for LAs for portcard 5.
#5 100-200 4 # default mapping for LAs for portcard 5.
B.12 /etc/grroute.conf
Contains the default route one is supposed to provide during first installation.
Routes to selected networks may also be entered here and will be brought up
automatically during start up procedures of the SP Switch Router.
# NetStar $Id: grroute.conf,v 1.3 1995/03/15 22:09:07 knight Exp $
#
# grroute.conf -- configuration file for GigaRouter static remote routes
#
# This file should only contain routes to remote networks and
# hosts--i.e., networks and hosts not directly attached to a
# GigaRouter interface. Routes for networks directly attached
# to the GigaRouter are created as part of configuring the
# GigaRouter interfaces; see /etc/grifconfig.conf.
#
# NOTE: THIS FILE SHOULD NOT BE USED ON SYSTEMS WITH DYNAMIC
# ROUTING (gated). If you are running gated, then you should specify
# static routes using the "static" statement in /etc/gated.conf.
#
# Whenever a port card boots, comes on line and has its interface(s)
# configured, the routes specified in this file that are for gateways
# on the network(s) directly attached to those interface(s) are
# configured into the BSD/386 kernel.
#
# The format of each line is follows:
#
# destination netmask gateway/next hop
#
# The destination is the IP address of the remote host or network.
# For the default route, specify a destination of "0.0.0.0" or the
# word "default".
#