Your IBM-4900 comes with a convenient belt clip and a headset jack. The headset jack gives you the option of us-
ing a cordless phone headset which, when used with the IBM-4900 belt clip, provides hands-free convenience. A
cordless telephone type headset utilizing a 2.5 mm connector plug has been included with your telephone.
Connecting the Headset to the Handset
I. Open the small rubber headset jack plug on the top of the handset.
2. Insert the 2.5 mm headset plug into this headset jack.
3. Enable the headset as instructed below.
NOTE:
A
belt
clip is provided with your IBM-4900. This clip slips over the back
of
the
handset and clips into the
openings on
the side
of
the
phone.
you
wish
remove the belt clip. use
small, flat
screw driver
pry the
the
handset.
To Disable the Handset Microphone
I. While the telephone is idle, press the [HOLD] key on the cordless handset.
2. Press the [I] key on the handset to disable the handset microphone.
3. A short ring will be heard to signal successful programming.
4. The
LED on handset will flash slowly confirming that the handset microphone is disabled.
To Enable the Handset Microphone
I. While the phone is idle, press the [HOLD] key on the handset.
2. Press the [0] key on the handset to enable the handset microphone.
3. A short ring will be heard to signal successful programming.
4. The
LED on handset will stop flashing slowly indicating the handset microphone is enabled.
NOTE:
The
headset must be enabled
disabled each
and every time you change
handset to headset, or
versa,
Making an Outgoing Call Using the Headset
I. Using the handset, press the
key or press an available [LINE] key.
2. Dial the desired number using the handset keypad.
3. At the end of the call, press the handset’s [END] key.
Answering an Incoming Call Using the Headset
I. Press the [TALK] key, you will be automatically connected to the ringing line.
29
SMARTHOME.COM™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Order #5125C
