IBM HS12 - BladeCenter - 8028, Installation And User Manual

Page: 34 / 78

tabs are fully seated. When the DIMM is correctly installed, the retaining
clips are parallel to the sides of the DIMM.
Important: If there is a gap between the DIMM and the retaining clips, the
DIMM has not been correctly installed. In this case, open the retaining clips
and remove the DIMM; then, reinsert the DIMM.
If you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 30.
Installing a concurrent KVM card
Use these instructions to install a concurrent KVM (CKVM) card in the blade
server.
To install a cKVM card, complete the following steps.
Notes:
1. The following illustration shows the location and how to install a cKVM card
in the system board.
2. The illustrations in this document might differ slightly from your hardware.
cKVM card
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 15.
2. If the blade server is installed in a BladeCenter unit, remove it (see
“Removing the blade server from the BladeCenter unit” on page 16 for
instructions).
3.
Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see “Opening the blade server cover” on page 17
for instructions).
24
BladeCenter HS12 Type 8014 or 8028: Installation and User's Guide