Release handles
(open)
Attention:
v
To maintain proper system cooling, do not operate the BladeCenter unit without
a blade server, expansion unit, or filler module installed in each blade server
bay.
v
When you remove the blade server, note the blade-server bay number.
Reinstalling a blade server into a different blade server bay from the one it was
removed from can have unintended consequences. Some configuration
information and update options are established according to blade-server bay
number; if you reinstall the blade server into a different bay, you might have to
reconfigure the blade server.
To remove the blade server, complete the following steps:
1.
If the blade server is operating, shut down the operating system; then, press the
power-control button (behind the blade server control panel door) to turn off
the blade server (see “Turning off the blade server” on page 13 for more
information).
Attention:
Wait at least 30 seconds, until the storage devices stop spinning,
before you proceed to the next step.
2.
Open the two release handles as shown in the illustration. The blade server
moves out of the blade server bay approximately 0.6 cm (0.25 inch).
3.
Pull the blade server out of the bay.
4.
Place either a blade filler or another blade server in the blade server bay within
1 minute.
Opening the blade server cover
Use these instructions to open the blade server cover.
To open the blade server cover, complete the following steps.
Note:
1.
The following illustration shows how to open the cover on the blade server.
2.
The illustrations in this document might differ slightly from your hardware.
Chapter 3. Installing options
17
Summary of Contents for HS12 - BladeCenter - 8028
