IBM HS12 - BladeCenter - 8028, Service Manual

Page: 71 / 204

Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v
Heat to more than 100° C (212° F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note:
1. The following illustration shows how to install the battery in the system board.
2. The illustrations in this document might differ slightly from your hardware.
To install the battery, complete the following steps:
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 31.
2. If the blade server is installed in a BladeCenter unit, remove it (see
“Removing the blade server from the BladeCenter unit” on page 33 for
instructions).
3.
Remove the blade server cover (see “Removing the blade server cover” on
page 35 for instructions).
4. If an optional expansion unit is installed, remove the expansion unit (see
“Removing an optional expansion unit” on page 37 for instructions).
5. Follow any special handling and installation instructions that come with the
battery.
6. Tilt the battery so that you can insert it into the socket.
7. As you slide the battery into place, press the battery down into the socket.
8. Install the optional expansion unit, if you removed one from the blade server
to replace the battery (see “Installing an optional expansion unit” on page 38
for instructions).
9. Install the blade server cover (see “Installing the blade server cover” on page
36 for instructions).
10.
Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 34 for instructions).
Chapter 5. Removing and replacing blade server components
59