IBM eServer xSeries 345 Type 8670, Installation Manual

Page: 33 / 71

Ethernet 1 link status LED: This green LED is lit when there is an active link
connection on the 10BASE-T, 100BASE-TX, or 1000BASE-TX interface for Ethernet
port 1.
Ethernet 1 activity LED: This green LED is lit when the server is transmitting to or
receiving signals from the Ethernet LAN that is connected to Ethernet port 1.
Server power features
This section contains information about how to properly turn your server on and off.
Turning on the server
You can turn on the server in any of the following ways:
v
If the power cords are connected to a power source, you can press the
power-control button on the front of the server.
Note: You can install a circular disk over the power-control button to prevent
accidental manual power-off. This disk, known as the power-control button
shield, comes with your server.
v
If the server is turned on and a power failure occurs, it restarts automatically
when power is restored.
v
You can turn on the server by using the optional Remote Supervisor Adapter.
v
You can turn on the server by using the Integrated System Management
Processor (ISMP)
v
When you plug in your server for the first time, Wake on LAN
™
can turn on the
server.
v
If your server was previously turned on, it must be properly placed in Standby
mode for the Wake on LAN feature to turn on the server.
Complete the following steps to manually turn on the server:
1. Review the information in “Safety” on page v.
2. Turn on all external devices, such as the monitor.
3. Plug the server power cords into the power source.
4. Press the power-control button on the front of the server.
Note: While the server is powering up, the power-on LED on the front of the server
is lit.
Chapter 3. Server power, controls, and indicators
21