IBM eServer xSeries 345 Type 8670, Installation Manual

Page: 17 / 71

Chapter 2. Installing options
This chapter provides the basic information needed to install options in your server.
This section is for all users, but it is written with the experienced user in mind. If
you need more detailed installation information, see the Option Installation Guide on
the IBM xSeries Documentation CD.
Installation guidelines
Be sure to review the information in this section before you begin.
System reliability considerations
Before you begin to install options in your server, read the following information:
v
Become familiar with the information provided in “Safety” on page v and
“Handling static-sensitive devices”. These guidelines will help you work safely
while working with your server options.
v
Make sure that you have an adequate number of properly grounded electrical
outlets for your server, monitor, and any other options that you intend to install.
v
Back up all important data before you make changes to hard disk drives.
v
For a list of supported options for your server, go to
http://www.ibm.com/pc/compat/ on the World Wide Web.
v
To maintain proper system cooling, do not operate the server for more than 10
minutes without either a drive or a filler panel installed in each bay.
v
During normal operation, each power-supply bay must have either a power
supply or power-supply blank installed for proper cooling.
v
Do not leave open spaces above or below an installed server in your rack
cabinet. To help prevent damage to server components, always install a blank
filler panel to cover the open space and to help ensure proper air circulation. See
the documentation that comes with your rack cabinet for more information.
Working inside the server with the power on
Your server supports hot-plug, hot-add, and hot-swap devices and is designed to
operate safely while turned on with the cover removed. Follow these guidelines
when you work inside a server that is turned on:
v
Avoid loose-fitting clothing on your forearms. Button long-sleeved shirts before
working inside the server; do not wear cuff links while you are working inside the
server.
v
Do not allow your necktie or scarf to hang inside the server.
v
Remove jewelry, such as bracelets, necklaces, rings, and loose-fitting wrist
watches.
v
Remove items from your shirt pocket (such as pens or pencils) that could fall into
the server as you lean over it.
v
Avoid dropping any metallic objects, such as paper clips, hair pins, or screws,
into the server.
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices and your system. To
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
© Copyright IBM Corp. 2002
5