IBM eServer xSeries 345 Type 8670, User Manual, Page: 31 / 68

– Select System Event/Error Log to view the System Error log. The System
Error log contains all the system error and warning messages that the system
has generated. You can use the arrow keys to move between pages in the
System Error log.
Select Clear event/error logs from the System Event/Error Log menu to
clear the System Error log.
v
Save Settings
Select this choice to save your customized settings (except PCI slot utility
changes).
v
Restore Settings
Select this choice to delete your changes and restore the previous settings.
v
Load Default Settings
Select this choice to cancel your changes and restore the factory settings.
v
Exit Setup
Select this choice to exit from the Configuration/Setup Utility program. If you have
made any changes and not saved them (except PCI slot utility changes), the
program will prompt you to save the changes or exit without saving the changes.
Additional Configuration/Setup Utility menu choices
When you install an IBM Remote Supervisor Adapter in your server, you can view
additional menu choices and additional information in the Configuration/Setup Utility
program, such as:
v
System Summary
Select this choice to display additional information about your server.
v
PCI Slot Information
Select this choice to view the properties of the adapters installed in PCI slots.
v
Administrator Password
Select this choice to set or change the administrator password.
v
Remote Control Security Settings
Select this choice to set a remote-control password. When you set a
remote-control password, you can also set the number of failed attempts to enter
the correct remote-control password, and the length of time before another
attempt is allowed.
Using passwords
The System Security choice appears only on the full Configuration/Setup Utility
menu. After you select this choice, you can implement two levels of password
protection: power-on password and administrator password.
Power-on password
After you set a power-on password, you can enable the Unattended-Start mode.
This locks the keyboard and mouse but enables the system to start the operating
system. The keyboard and mouse remain locked until you type the correct
password.
You can use any combination of up to seven characters (A–Z, a–z, and 0–9) for
your power-on password. Keep a record of your password in a secure place. When
a power-on password is set, POST is not completed until you type the password. If
you forget the power-on password, you can regain access to the server through one
of the following methods:
Chapter 2. Configuring your server
19