IBM eServer xSeries 345 Type 8670, User Manual, Page: 29 / 68

– The default setting is Enabled for all the controllers available from this menu.
If you select Disabled, the system will not configure the disabled device, and
the operating system will not detect the device. (This is equivalent to
unplugging the device.)
– If the SCSI controller is disabled and no SCSI adapter is installed, the server
will have no SCSI capability.
– If the on-board Ethernet controller is disabled and no Ethernet adapter is
installed, the server will have no Ethernet capability.
v
Date and Time
Select this choice to set the system date and time. This choice appears only on
the full Configuration/Setup Utility main menu.
The system time is in a 24-hour format (hour:minute:second).
v
System Security
Select this choice to set passwords or the Remote Control Security settings. This
choice appears only on the full Configuration/Setup Utility main menu.
You can implement password protection using the following passwords:
– Power-on Password
Select this choice to set or change a power-on password. See “Using
passwords” on page 19 for more information.
– Administrator Password
Note: This choice is available on the Configuration/Setup Utility menu only if
the optional IBM Remote Supervisor Adapter is installed in your server.
Select this choice to set or change an administrator password.
Attention: If an administrator password is set and then forgotten, it cannot
be overridden or removed. You must replace the system board.
The administrator password provides access to all choices on the
Configuration/Setup Utility main menu. You can set, change, or delete both
the administrator and power-on passwords and allow a power-on password to
be changed by the user.
See “Using passwords” on page 19 for more information.
v
Start Options
Select this choice to view or change the start options. This choice appears only
on the full Configuration/Setup Utility main menu. Start options take effect when
you start your server.
You can select keyboard operating characteristics, such as the keyboard speed.
You also can specify whether the keyboard number lock starts on or off. You also
can enable the server to run without a diskette drive, monitor, or keyboard.
The server uses a startup sequence to determine the device from which the
operating system is loaded. For example, you can define a startup sequence that
checks for a startable diskette in the diskette drive, then checks the hard disk
drive in bay 1, and then checks a network adapter.
If your server contains Wake on LAN
™
hardware and software and your
operating system supports Wake on LAN functions, you can also define a startup
sequence for the Wake on LAN functions.
Chapter 2. Configuring your server
17