IBM eserver p Series, Installation Manual

Page: 23 / 76

Step 6. Installing Drawers in the Rack
CAUTION:
This unit weighs between 32 kg (70.5 pounds) and 55 kg (121.2 pounds). Three
persons are required to safely move it. Using fewer than three persons to move it
can result in injury.
To install the drawers in the rack, do the following:
1. Slide the shipping box containing the drawer in front of the rack.
2. If the front door of the rack is present, remove it to make installing the drawer
easier.
3. Remove the following parts to facilitate lifting the drawer into the rack unit:
v
Front bezel
v
Both power supplies
4. Lift the drawer onto the support rails, and slide it
slowly into the rack.
5. Continue sliding the drawer into the rack until the front of the drawer rests against
the nut clips on the rack.
6. Attach the rear of the drawer to the rack rails with the two hex flange screws and
the two flat washers provided with the drawer. This action secures the drawer to the
rack.
Chapter 1. Setting Up the System
9