IBM Eserver 345 Series, Option Installation Manual

Page: 48 / 70

12. Start the Configuration/Setup Utility program and set configuration parameters
as needed. See the User’s Guide on the IBM xSeries Documentation CD for
additional information about using the Configuration/Setup Utility program.
Completing the installation
To complete your installation, reinstall the bezel, reinstall the server cover,
reconnect all cables that you disconnected earlier, and for certain options, run the
Configuration/Setup Utility program. Follow the instructions in this section.
Attention:
v For proper cooling and airflow, replace the server cover before or shortly after
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
v To ensure proper server operation, do not remove the air-baffle assembly from
the server except when installing or removing the components that are located
under the air baffle.
Installing the server cover and bezel
The following illustration shows how to install the server cover and bezel.
Cover-release latch
Bezel
Complete the following steps to install the server cover:
1. Place the cover-release latch in the open (up) position.
2. Insert the bottom tabs of the top cover into the matching slots in the server
chassis.
3. Press down on the cover-release latch to lock the cover in place.
Complete the following steps to install the bezel:
1. Align the hooks on the bottom of the bezel with the server.
2. Press the bezel toward the server until it clicks into place.
Installing the server in a rack
Detailed cabling instructions for a typical rack server configuration are in the Rack
Installation Instructions that come with your server.
Updating your server configuration
When you start your server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
36
IBM xSeries 345 Type 8670: Option Installation Guide