IBM BladeCenter HS22V, Installation And User Manual

Page: 44 / 108

Removing the bezel assembly
Use this information to remove the bezel assemble from the blade server.
The following illustration shows how to remove a bezel assembly from a blade
server.
Note:
1. The illustrations in this document might differ slightly from your hardware.
To remove the bezel assembly, complete the following steps.
Bezel assembly
Bezel assembly
release (both sides)
Control-Panel
Connector
Control-Panel
Cable
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 19.
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 21 for instructions).
3. Open the blade server cover (see “Removing the blade server cover” on page
22 for instructions).
4. If an optional expansion unit is installed, remove it (see “Removing an optional
expansion unit” on page 24).
5.
Carefully lay the blade server on a flat, static-protective surface.
6. Press the bezel-assembly release on each side of the blade server and pull the
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
7. If you are removing the bezel assembly from a blade server, disconnect the
control-panel cable from the control-panel connector by lifting up on the
control-panel cable.
Note: Some hardware installation and removal procedures that refer to this
removal process do not require the control-panel cable to be removed. For
example, the DIMM connectors can be accessed without removing the
control-panel cable.
8.
Pull the bezel assembly away from the blade server.
9. If you are instructed to return the bezel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
28
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide