IBM BladeCenter HS22V, Installation And User Manual

Page: 43 / 108

Installing the bezel assembly
Use this information to install a bezel assembly in the blade server.
Note:
1. The following illustration shows how to install a bezel assembly in a blade
server.
2. The illustrations in this document might differ slightly from your hardware.
To install the bezel assembly, complete the following steps.
Bezel assembly
Bezel assembly
release (both sides)
Control-Panel
Connector
Control-Panel
Cable
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 19.
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 21 for instructions).
3. Carefully lay the blade server on a flat, static-protective surface.
4.
Open the blade server cover (see “Removing the blade server cover” on page
22 for instructions).
5. If an optional expansion unit is installed, remove it (see “Removing an optional
expansion unit” on page 24).
6.
Orient the bezel with the front of the blade server.
7. If the control-panel cable is not already installed, connect the control-panel
cable to the control-panel connector on the blade server.
Note: Some hardware installation and removal procedures that refer to this
installation process do not require the control-panel cable to be installed. For
example, the DIMM connectors can be accessed without removing and
reinstalling the control-panel cable.
8. Carefully slide the bezel assembly onto the blade server until it clicks into
place.
9.
Install the optional expansion unit, if you removed one from the blade server
(see for instructions).
Chapter 3. Installing options
27