__ 3.
Set up the workstation or personal computer (PCs) that will be connected to
the system unit and used as the console.
Notes:
a.
Place the workstation or PC that will be used as the system unit console
not more than 6 meters (20 feet) from the system unit.
b.
Follow the instructions that came with the workstation or PC to set it up.
__ 4.
Find the Twinaxial console cable and label it
console cable
.
__ 5.
Align the key
B
in
port 0
on the 8-port Twinaxial cable connector with the
slot
A
on the Twinaxial cable ( Figure 3) attachment.
Push in, hold, and turn the outer ring until it is tight.
__ 6.
Connect the other end of the Twinaxial console cable to the PC or
workstation that is the system unit console.
Note:
The workstation address of your console
must be set to 0
. To set the
address, refer to the book that was shipped with your device.
__ 7.
Install the side and back covers.
__ 8.
DANGER
An electrical outlet that is not correctly wired could place hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer’s responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock.
(RSFTD201)
Plug the following power cords into an electrical outlet.
v
System unit
Note:
Do
not
power on your AS/400 system unit at this time.
v
System unit console
Figure 3. Where to Connect the System Unit Console Cable
Before you begin
7
Summary of Contents for AS/400e 270
Page 2: ......
Page 11: ...Figure 1 Example of 270 820 5075 Card Latch Before you begin 5...
Page 33: ......
