IBM Aptiva, Hardware Maintenance Manual, Page: 125 / 282

4-22
NOTE: Pentium II Processor Install
If the retention module is not already installed on the system board:
•
Place the EMC clip over the correct post on the screw bracket.
•
Press the screw bracket onto the bottom of the system board.
Note: Be sure the EMC Clips are aligned with the holes with ground pad
on the system board.
•
Turn the system board over.
•
Place the retention mechanism over the socket on the system board make
sure the groove matches the one on the processor socket.
Figure 4- 23 Installing the Pentium II Retention Mechanism
To install processor to retention module:
•
With the processor module golden fingers pointing downward, align the
processor to the posts of the retention mechanism then lower it down.
•
The golden fingers of the Pentium II module is slotted such that it only fits
in one direction. Make sure that module groove matches the one on the
processor socket.