IBM Aptiva 2165, Hardware Maintenance Service, Page: 77 / 167

2-11
Table 2-1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, beeps Action/FRU
NOTE: To diagnose a problem, first find the BIOS error messages, codes,
or beeps in left column. If directed to a check procedure, replace the FRU
indicated in the check procedure. If no check procedure is indicated, the first
Action/FRU listed in right column is the most likely cause.
1780
Primary master hard disk
failure
1781
Primary slave hard disk failure
A warning message to indicate there has
been change of IDE Primary (Secondary)
Channel Master (Slave) device.
Load default settings in Setup.
Check IDE drive jumper. See “3.5-In. Hard
Disk Drive Jumper Locations” on page 5-11.
IDE drive power.
IDE drive cable/connection.
IDE drive.
1782
Secondary master hard disk
failure
1783
Secondary slave hard disk
failure
A warning message to indicate there has
been change of IDE Primary (Secondary)
Channel Master (Slave) device.
Load default settings in Setup.
Check IDE drive jumper. See ”3.5-In. Hard
Disk Drive Jumper Locations” on page 5-11.
IDE drive power.
IDE drive cable/connection.
IDE drive.
8602
PS/2 Mouse error on no PS/2
Mouse present
Make sure the PS/2 mouse is connected
properly and are set correctly in BIOS Setup.
Mouse.
System board.
SYSTEM HALTED, (CTRL-
ALT-DEL) TO REBOOT ... Indicates the present boot attempt has been
aborted and the system must be rebooted.
Press and hold down the CTRL and ALT
keys and press DEL.
Hard Disk(s) failure (80) HDD reset failed.
Hard Disk(s) failure (40) HDD controller diagnostics failed.
Hard Disk(s) failure (20) HDD initialization error.
Hard Disk(s) failure (10) Unable to recalibrate fixed disk.