IBM AnyPlace 4836, Planning, Installation And Service Manual

Page: 48 / 108

Locating and resetting the CMOS jumper
Follow these steps to locate and reset the CMOS jumper:
1. Remove the cover as described in “Removing the back cover” on page 28.
2. Locate the blue CMOS jumper on the main planar assembly. See Figure 19.
The jumper is located near the hard drive and beside the radio card.
3. Remove the jumper from the board and wait several seconds.
4. Reinstall jumper to reset defaults.
Figure 19. Location of the CMOS jumper
32
Anyplace Kiosk 4836