IBM AnyPlace 4836, Planning, Installation And Service Manual

Page: 30 / 108

2. See Figure 9. Remove the two captured screws on each side of the memory
door and pull to remove.
3. Insert the memory card into the brackets at an angle with the connector end
down.
4. Rotate the outer edge of the memory card downward until it snaps into place.
Note: You must remove the back cover if you are replacing both memory modules.
Mounting instructions
You can choose between a table-top, wall mount, or a third party mount.
Figure 9. Installing additional memory
14
Anyplace Kiosk 4836