IBM AnyPlace 4836, Planning, Installation And Service Manual

Page: 27 / 108

Installing the scanner
1. As shown in Figure 5, place the IBM 4836 face down on a sturdy surface.
2. Lift the cable covers as described in “Opening the cable covers” on page 9.
3. Unfasten the screw (
A
) holding the scanner bay cover (
B
). Discard the
cover, but retain the screw for step 6.
4. Connect the scanner cable (
C
) to the connector (
E
).
5. Align the tabs (
D
) on the scanner with the adjacent slots on the cover and
slide into position.
6. Secure in place by inserting the screw (
A
).
Note: For best scanning results, hold the object to be scanned 2 to 4 inches away
from the scanner.
Installing the MSR
Note: Install the MSR after you mount the IBM 4836. See “Mounting instructions”
on page 14.
1. See Figure 6 on page 12. Remove the hard drive door by unfastening the two
screws located on the door and discard.
2. With the IBM 4836 mounted onto the desired stand, locate the mounting
features for the MSR on the right side of the machine.
C
D
A
B
E
Figure 5. Installing the scanner
Chapter 2. Installing the IBM Anyplace Kiosk
11