IBM AnyPlace 4836, Planning, Installation And Service Manual

Page: 47 / 108

Removing the wireless card
Follow these steps to remove the wireless card:
Note: You do not have to remove the back cover to remove the wireless card.
1. Place the 4836 face down on a sturdy surface.
2. Remove the two captured screws and lift to remove the hard drive door (see
A
in Figure 18). This door allows you access to the optional wireless card.
3. Rotate the antenna connectors upward to disconnect, noting the AUX and MAIN
labels (
B
and
C
) on the cables.
Note: Take care not to crimp these cables.
4. Locate and press outward on the card brackets to unlock.
5. Lift out the wireless card.
6. To replace, angle the card downward, then rotate the opposite end down until it
latches into place.
7. Reconnect the antenna, ensuring that the AUX and MAIN antenna correctly
match the connectors.
8. Replace the hard drive door and secure the screws.
B
C
A
Figure 18. Removing the wireless card
Chapter 4. Removing and replacing FRUs
31