IBM AnyPlace 4836, Planning, Installation And Service Manual

Page: 29 / 108

Installing the upgrade options
Note: Most internal upgrade options are ordered and arrive pre-installed. This
section is provided for technical personnel only.
Installing a hard drive
See Figure 2 on page 8 to identify the hard drive access door.
1. Place the IBM 4836 face down on a sturdy surface.
2. Unfasten the two captured screws to remove the HDD door (
A
) . See
Figure 8.
3. Locate the slot and brackets and insert the hard drive (
B
).
Note: Note the optional wireless card (
C
). If ordered, this card is installed at the
factory. For removal and replacement procedures, see“Removing the
wireless card” on page 31.
Installing additional memory
To install additional memory refer to Figure 2 on page 8. This figure identifies the
memory access door.
1. Place the 4836 face down on a sturdy surface.
Figure 8. Removing the hard drive cover
Chapter 2. Installing the IBM Anyplace Kiosk
13