9.7
9.8
If using an external modem, plug the power cord into the modem.
CAUTION: This product is equipped with a 3-wire (two conductor and a ground)
power cable and plug. Use this power cable with a properly grounded electrical
outlet to avoid electrical shock. (C018)
You have completed the basic setup. Go to task 11
Finish your system setup.
9.9
Start and configure the HMC, which includes the Guided Setup Wizard. You can find the
instructions for configuring the HMC in the IBM SystemsHardware Information Center. For
details about how to access the information center, see task 11
.
Finish your system setup
9.10
9.11
Connect the server to a power source and wait for the control panel on the front of the
server to display
. This might take several minutes.
01
Press the white Power On button on the control panel.
9.6
Connect the Ethernet cable to the Ethernet port on the HMC and to the
Ethernet port labeled HMC1 on the server.
For a stand-alone HMC, use the integrated Ethernet port. For the 7310-CR2 rack-mounted
HMC, use the bottom-right Ethernet port. For the 7310-CR3 rack-mounted HMC, use the
left port of the two planar board Ethernet ports.
Plug the power cords for the monitor, HMC, and external modem into a power source. Do
not connect the server to a power source until instructed to do so.
Route the cables through the cable-management arm on the server and secure the
cables with the straps provided.
9.12
