IBM 8835 - Eserver 325 - 1 GB RAM, User Manual, Page: 28 / 68

v
System Security
Select this choice to set passwords. See “Passwords” on page 15 for more
information.
This choice is on the full Configuration/Setup Utility menu only.
– User Password
Select this choice to set or change a user password. See “User password” on
page 15 for more information.
– Supervisor Password
This choice is on the Configuration/Setup Utility menu only if an optional IBM
Remote Supervisor Adapter II is installed.
Select this choice to set or change a supervisor password. A supervisor
password is intended to be used by a system administrator; it limits access to
the full Configuration/Setup Utility menu. If a supervisor password is set, the
full Configuration/Setup Utility menu is available only if you type the supervisor
password at the password prompt. See “Supervisor password” on page 16 for
more information.
v
Power Management
Select this choice to view, set, and change power-management features for the
server. To use some of these features, such as
Wake up by LAN , your server
must contain Wake on LAN hardware and software and your operating system
must support Wake on LAN functions.
– Power Savings
– Standby Timeout
– Auto Suspend Timeout
– Resume On Modem Ring
– Wake up by LAN
– Resume On Time
– Resume Date
– Resume Time
– After Power Failure
v
Startup
Select this choice to view or change the primary, automatic, and error startup
sequences. Startup sequences take effect when you start the server. You can
select up to four primary and four automatic startup devices through the
Startup
Sequence menu.
The startup sequence specifies the order in which the server checks devices to
find a boot record. The server starts from the first boot record that it finds. If your
server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that
checks for a CD or DVD in the CD-ROM drive, then checks the hard disk drive,
and then checks a network adapter.
You can enable a virus-detection test that checks for changes in the master boot
record at startup.
This choice is on the full Configuration/Setup Utility menu only.
v
Save Settings
Select this choice to save the changes you have made in the settings.
14
IBM
Eserver
325 Type 8835: User’s Guide